Practical Backpacking™ Forums

Welcome to Practical Backpacking™ Forums (PBF).

You are currently viewing PBF as a guest which has limited access. By becoming a PBF member, you will have full access to view and participate in tens of thousands of informative discussions, to view links and attachments (photos), and will gain access to other special features. Registration is fast, simple and absolutely free! Click to Become a PBF Member! Be sure to also explore the Practical Backpacking Podcast.


Go Back   Practical Backpacking™ Forums > Practical Backpacking™ Safety & Sustenance > Backcountry Kitchen
HOME FAQ PBF GUIDELINES BLOG PODCAST GALLERY STORE CALENDAR Mark Forums Read

Backcountry Kitchen The Backcountry Kitchen forum is for the discussion of food and cooking gear related topics for backpacking trips (e.g. menus, recipes, stoves, fuel...).


Reply
 
Thread Tools Display Modes
  #11  
Old 02-17-2015, 02:34 PM
© 2006-2016 Practical Backpacking™ / All Rights Reserved
dsuursoo dsuursoo is offline
Practical Backpacking­™ Senior Member
Backpack: Mountainsmith Maverick 65
Sleeping Gear: ALPS +20 mummy
Shelter: Kelty Noah 9x9
 
Join Date: Apr 2009
Posts: 1,482
Well in its simplest form the ground plate is basically a circular sheet of the same material as your wind screen. Lay it under the stove, then stove, wind screen goes over that once stove is lit and thenadd the pot. The plate acts as a reflector, keeping radiant heat that might be lost to the ground focused where you want it. It also protects the surface under the stove from heat/flame.

Its not a lot of efficiency gain. Maybe a few percent. But when you're tuning up even a few percent can make a difference.

It should be made of a light but resilient material that folds/rolls easily and flattens out well. Or stiff and durable and keep it with your bowl. The wind screen for snow peak gigapower stoves would be a suitable stiff/durable one, to give you an idea of what it would look like.


On windscreen: someone else with more alky stove experience can back me up here but I recall the optimal spacing is in the 3/8 too 1/4 inch range. It should have enough airflow to feed the stove plus a little. The higher the better. If you can get it close to the top of the pot that gives you maximum heat transfer.

Good luck.
Reply With Quote
Reply


Thread Tools
Display Modes

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Caldera Cone (with Snow Peak 600) Observations Reality Backcountry Kitchen 15 09-23-2009 10:25 PM
My Homemade Alcohol Stoves Experience nzbazza Gear Workshop 16 09-01-2009 06:52 PM
Alcohol Stove and Tin Can Cookpot eay Backcountry Kitchen 8 12-30-2008 09:46 AM
Homemade Alcohol Stove Challenge Reality Gear Workshop 25 06-11-2007 06:46 PM



All times are GMT -7. The time now is 12:37 AM.

Backpacking Forums


Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright © 2006-2017 Practical Backpacking™
Practical Backpacking is a trademark of Absolutely Prepared™
Practical Backpacker is a trademark of Absolutely Prepared™
Practical Backpacking Podcast is a trademark of Absolutely Prepared™
Practical Backpacking Magazine is a trademark of Absolutely Prepared™