|
|
|
Welcome to Practical Backpacking™ Forums (PBF). You are currently viewing PBF as a guest which has limited access. By becoming a PBF member, you will have full access to view and participate in tens of thousands of informative discussions, to view links and attachments (photos), and will gain access to other special features. Registration is fast, simple and absolutely free! Click to Become a PBF Member! Be sure to also explore the Practical Backpacking Podcast. |
|
|||||||
| General Gear Discussion The General Gear Discussion forum is for the discussion of traditional and lightweight (ultralight) backpacking gear that is not covered in other Practical Backpacking™ forums. [Please post about Backpacks, Shelters, Sleeping Gear, Backcountry Kitchen (Food, Stoves) in those respective forum areas.] |
| View Poll Results: Which edge type do you prefer for a general carry pocket knife? | |||
| Straight |
  
|
33 | 89.19% |
| Serrated (Partial) |
  
|
4 | 10.81% |
| Voters: 37. You may not vote on this poll | |||
 |
|
|
Thread Tools | Display Modes |
|
#11
02-29-2012, 10:24 PM
|
|||
|
|||
|
I have a Veff for a work knife. I got it because it looked easy to sharpen an it is. Its not like normal serration that saw but it is very useful. I install main stem communications an use it to cut the abrasion resistant cordage we use to pull the Fiber Optic cable. This stuff will dull a sharp knife in a few cuts but the Veff rips right through it. I have also used it to cut cable. its the only serrated knife I would carry.
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Smooth (Side) Edge Can Opener | Wonderboy | Gear Workshop | 11 | 09-29-2010 02:32 PM |
| 35° Down Quilt (Full Tutorial w/Photos) | Mike_in_FHAZ | Gear Workshop | 48 | 05-27-2010 09:26 AM |
| Edge Binding on Silnylon Tarps | Reality | Shelters | 4 | 12-17-2009 01:52 PM |
| How to Add a Zip Vent to a Jacket | yippikiyo | Gear Workshop | 15 | 03-04-2008 01:59 PM |
| Smooth Edge Can Opener to make lid for Snow Peak 600 Ti Mug | Reality | Gear Workshop | 17 | 05-02-2006 02:53 PM |
Linear Mode
